PLEASE READ THIS GUIDE CAREFULLY PRIOR TO APPLICATION OF ANY STICKERS.

WE CANNOT REPACE VINYL DAMAGED DUE TO APPLICATION ERRORS.

Step 1

Clean the area thoroughly. Place the sticker in the desired location. Put a piece of masking tape on one

side of the sticker to hold it in place.

Lift the sticker up and peel the white paper backing off the sticker. Be careful not to pull the masking

tape off.

Hold the side opposite to the masking tape and pull slightly to keep tension

on the sticker (Do not pull too hard or the masking tape will come loose).

Rub the sticker in place , starting from the masking

tape, rub firmly left to right, moving away from the masking tape with

each pass.

Slowly peel the application tape off at an angle. Be very careful not to pull the

sticker off the surface. If the sticker pulls away from the surface repeat step 3.

If air bubbles are present after application, prick with a sharp knife or pin, then rub up to the

prick, any air should escape.

When cleaning the area prior to application, use soap & water, meths, alcohol, etc. The surface must be

free from dirt, dust, wax, etc. If the surface is not clean the sticker may not stick properly or come off

shortly after application.

For best results do not install the sticker in extreme heat or cold. When warm

the vinyl will stretch and when cold it becomes brittle and may tear.

For larger stickers, start at the top middle and then work to the outer edges.

If applying text, cut into sections and apply each section separately.